Porsche 911 Turbo 6 speed manual
Sale price: US $55,000.00 Make an Offer
| Condition: | Used | Year: | 2008 |
| VIN : | WP0CD29988S789495 | Mileage: | 48338 |
| Model: | 911 | Number of Cylinders: | 6 |
| Interior Color: | Black | Transmission: | Manual |
| Exterior Color: | Black | Vehicle Title: | Clean |
| Make: | Porsche | Body Type: | Convertible |
Hannibal, Missouri, United States
Vehicle description
2008 Porsche 911 Turbo 6-speed manual VIN: WP0CD29988S789495 Black on Black Division: PCNA Commission #: 664296 Prod Month: 2008-03-01 VIN: WP0CD29988S789495 Price: $141,040.00 Exterior: Black Interior: Black Full Leather Warranty Start: April 17, 2008 BASE 911 Turbo Cabriolet 342 Heated Seats 404 19" Turbo wheels 437 Standard Seats 480 Manual gearbox 640 Sport Chrono Package Turbo 692 Six-disc CD autochanger 810 Floor Mats in Interior Color A1 Black AT Black Full Leather CGA Headlight Cleaner Cvr Ext.Clr V9 Cabriolet roof in Black XSC Porsche Crest in Headrests Work done since 2019: 1. 40k Service (10/22/2019) – Invoice posted - Spark plugs - Brake fluid flush - Cabin filter - Air filter - Oil change and filter 2. Cam sensor replaced bank 1 3. Cup holder repaired Work done since 2020 (1/30/2020): DRAIN FLUIDS AND REMOVE ENGINE/TRANSAXLE ASSEMBLY. REMOVE INTAKE AND FRONT PULLEY TO ACCESS COOLANT PIPES. PIN ALL COOLANT OUTLETS. INSTALL SUPPLIED REAR WATER OUTLET KIT (Sharkwerks elbows) REMOVE AND REPLACE WATER PUMP WITH SUPPLIED PARTS. REPLACE ACCESSORY DRIVE BELT WITH SUPPLIED PART. REMOVE AND REPLACE COOLANT THERMOSTAT WITH SUPPLIED PARTS. REPLACE CLUTCH SLAVE CYLINDER WITH SUPPLIED PARTS. REMOVE AND REPLACE IGNITION COILS WITH SUPPLIED PARTS. SEPARATE ENGINE FROM TRANSAXLE AND REMOVE CLUTCH ASSEMBLY. REMOVE AND REPLACE REAR MAIN CRANK SEAL WITH SUPPLIED PART. REPLACE AND INSTALL CLUTCH ASSEMBLY WITH SUPPLIED PARTS. REMOVE AND REPLACE FUEL FILTER WITH SUPPLIED PART FLUSH FRONT AND REAR DIFFERANTIALS WITH SUPPLIED FLUIDS. DRAIN AND REFILL DIFFERANTIAL CONTROL FLUID FROM TRANSFER CASE. REMOVE AND REPLACE COOLANT RESERVOIR WITH SUPPLIED PARTS. REMOVE AND REPLACE CLUTCH MASTER CYLINDER AND RESERVOIR WITH SUPPLIED PARTS REATTACH ENGINE TO TRANSAXLE AND INSTALL ASSEMBLY BACK INTO CHASSIS. REMOVE REAR WING HYDRAULIC CONTROL. SET UP WING TO BE FIXED OPEN AS INSTRUCTED BY OWNER. REFILL FLUIDS. START ENGINE AND RECHARGE A/C FREON. RUN ENGINE TO TEMPETURE AND FINAL FILL COOLANT. CHECK FOR ANY LEAKS. TEST DRIVE CAR. Currently has a hard-top which is included tires 9/32 on all 4 corners brake pads 8mm on all 4 corners Full front PPF