Jeep Gladiator Pickup White 4WD Manual RUBICON (2020)
Sale price: US $1.00 Make an Offer
| Used |
| “Payment by wire transfer” |
| Year: | 2020 | VIN : | 1C6JJTBG3LL115618 |
| Mileage: | 33600 | Body Type: | Pickup |
| Fuel Type: | Gasoline | Trim: | RUBICON |
| For Sale By: | Private Seller | Transmission: | Manual |
| Model: | Gladiator | Number of Cylinders: | 6 |
| Exterior Color: | White | Make: | Jeep |
| Vehicle Title: | Clean | Drive Type: | 4WD |
| Engine: | 3.6L Gas V6 |
Marietta, Georgia, United States
Vehicle description
About this vehicle This 2020 Jeep Gladiator is an original with updates to the exterior, interior and drivetrain. The owner has had it for 2 years. The vehicle runs great and is used as a daily driver. Seller"s Notes Payment by wire transfer Vehicle Details Up for sale is my 2020 Jeep Gladiator Rubicon. I ordered it in May of 2019. It was delivered in July of that year. The Jeep has 33,600 miles on it. It drives great. I just put 6500 miles on it this summer camping across the US. The Gladiator comes with the 3.6 V6 with an S&B intake and Magnaflow exhaust. The hood has Poison Spyder louver panels to help with the heat. The jeep is a factory manual 6 speed. The Rubicon Dana 44 axles have been regeared to 4.88. I installed a Skyjacker 3.5 inch lift. It comes with front shock relocators. Tires and wheels are BFG Mud Terrain KM3s in 39.5x13.60R17 on Hutchinson Rock Monster Beadlocks. The Beadlocks are street legal. They balance and ride great. I have a full-size matching spare to rotate around. The wheels have been powder coated blue. There is a 35 inch spare under the truck also. The speedometer was recalibrated with a Superchips Flash Cal. I swapped the soft top for a factory hard top. I also added a headliner kit to the top. The jeep comes with a factory tonneau cover. Currently, there is an ARE truck topper installed. It is actually Gator Green in color. It has been wrapped in flat back vinyl. The wrap job is mediocre. It comes with a set of roof bars for the topper. JCR Molly panels are installed in the bed. A Hylift jack is bolted in the bed. The front bumper is Warn with a 12k Platinum synthetic winch. N-Fab side steps were installed to help with getting in and out. The factory headlights have been swapped for a pair of Hella H4 lights. The brackets used will allow for a 7 inch LED to be installed if you like. Rigid reverse lights are mounted under the rear bumper. They are wired to one of the factory AUX switches/. Procomp rock lights are installed in the wheel wells, and under the bumpers and steps. They are also wired to a factory AUX switch. The factory brown leather seats are covered with Wet Okole neoprene seat covers. The front covers have seat heaters. I added a Cobra 75 CB in the cab also. The only issues with the truck are the TPMS light and the shocks squeak. All of the TPMS sensors read perfectly, but the light comes on. It has something to do with the thicker wheels and the sensor placement in them. They did the same on my last jeep. There isn’t a problem with the system. Just something to note. The rear shocks squeak going over the bumps. I only notice it with the radio off. The title is clean and ready to go. I am located in Marietta, Ga. I can assist with loading if you have a shipper, to pick you up at the Atlanta airport if you want to drive it home. Exterior Interior Download the Motors app