Dodge Power Wagon Club Cab 4x4 V8 5.9L (360ci) - solid truck (1979)
Sale price: US $5,500.00 Make an Offer
| Condition: | Used | Year: | 1979 |
| VIN : | w17jf9c117691 | Mileage: | 150200 |
| Number of Cylinders: | 8 | Engine: | 360ci |
| Model: | Power Wagon | Transmission: | Automatic |
| Drive Side: | Left-hand drive | For Sale By: | Private Seller |
| Disability Equipped: | No | Fuel Type: | Gasoline |
| Drive Type: | 4WD | Warranty: | Vehicle does NOT have an existing warranty |
| Sub Model: | W150 | Exterior Color: | Brown |
| Interior Color: | Tan | Trim: | Club Cab |
| Vehicle Title: | Clean | Options: | 4-Wheel Drive |
| Body Type: | Extended Cab Pickup | Make: | Dodge |
Gresham, Oregon, United States
Vehicle description
1979 Dodge W150 Club Cab Power Wagon - 50,250 miles shown, actual mileage unknown but likely 150k. Message me for more photos or look at previous listing. Highest bid takes it!
Drivetrain: 360 ci (5.9L), 3-spd automatic, full-time four wheel drive with locking center differential (NP203). Power steering, power brakes,A/C truck but A/C components are not present. MSD distributor, Digital 6AL spark controller, Blaster 2 coil and 8.5mm plug wires. Edelbrock four-barrel intake. Radiator fan shroud included in sale (not installed). Engine work completed at 145k mi (March 2019) Engine Gasket Set Oil Pan gasket, front crankshaft seal. Fuel Pump Water Pump Timing Set (3-piece) Engine Mounts Radiator hoses Catalytic Converter Fuel Filters Cylinder Head machining Runs and drives well. Interior: No carpet, floors have been sprayed with undercoating/ Line-X type material. Tilt steering, aftermarket tachometer, rear seats included but not sure if all required mounting hardware is present. Aftermarket rear seat belts(never installed) included with sale. Exterior: Brown with tan (I believe it is referred to as Sable Sunfire Metallic with Cashmere side stripe). Very little rust . I"m not able to locate any, other than mild surface rust. Has aftermarket front push-bumper. Used, non-painted grille included in sale. Heavy-duty rear bumper, aftermarket LED backup light mounted on bumper. 31x10.50 on 15 inch steel wheels. The Bad: Body panels are not straight. There are many dents,dings, scratches and gouges, but the absence of rust makes this a very good starting point for the right body-man. May be able to straighten a few of the dents with some skill and elbow grease. Rear tailgate does not open (release mechanisms appear to have become disconnected from the handle). There is only one fuel tank in the rear of the truck under the bed. The fuel tank under the front of the bed has been removed(see photos). The filler hole / cap is still present but the filler neck is not connected into anything. HID Headlight kit installed but it is not working properly so lights only function on high beam. Headlight connectors have not been cut so fixing HID or reverting back to stock is an option. Window rollers are missing. Passenger window is off of the track and will need work to go up/down freely. Rear window rubbers for club-cab windows are poor and windshield seal leaks There has been some patchwork done on the dash/instrument panel. Seats are ripped and door panels are weathered.
In person viewing can be arranged. Please send a message to arrange an appointment. VIN Breakdown: W = 4 wheel drive pickup 1 = 100 (1/2 ton) 7 = club cab sweptline J = 6,000 - 8,500 lbs (1979) F = 360ci 9 = 1979 C = Jefferson Plant
Buyer will be responsible for shipping but I can assist with coordinating or put the buyer in contact with a local shipper for a quote.
Drivetrain: 360 ci (5.9L), 3-spd automatic, full-time four wheel drive with locking center differential (NP203). Power steering, power brakes,A/C truck but A/C components are not present. MSD distributor, Digital 6AL spark controller, Blaster 2 coil and 8.5mm plug wires. Edelbrock four-barrel intake. Radiator fan shroud included in sale (not installed). Engine work completed at 145k mi (March 2019) Engine Gasket Set Oil Pan gasket, front crankshaft seal. Fuel Pump Water Pump Timing Set (3-piece) Engine Mounts Radiator hoses Catalytic Converter Fuel Filters Cylinder Head machining Runs and drives well. Interior: No carpet, floors have been sprayed with undercoating/ Line-X type material. Tilt steering, aftermarket tachometer, rear seats included but not sure if all required mounting hardware is present. Aftermarket rear seat belts(never installed) included with sale. Exterior: Brown with tan (I believe it is referred to as Sable Sunfire Metallic with Cashmere side stripe). Very little rust . I"m not able to locate any, other than mild surface rust. Has aftermarket front push-bumper. Used, non-painted grille included in sale. Heavy-duty rear bumper, aftermarket LED backup light mounted on bumper. 31x10.50 on 15 inch steel wheels. The Bad: Body panels are not straight. There are many dents,dings, scratches and gouges, but the absence of rust makes this a very good starting point for the right body-man. May be able to straighten a few of the dents with some skill and elbow grease. Rear tailgate does not open (release mechanisms appear to have become disconnected from the handle). There is only one fuel tank in the rear of the truck under the bed. The fuel tank under the front of the bed has been removed(see photos). The filler hole / cap is still present but the filler neck is not connected into anything. HID Headlight kit installed but it is not working properly so lights only function on high beam. Headlight connectors have not been cut so fixing HID or reverting back to stock is an option. Window rollers are missing. Passenger window is off of the track and will need work to go up/down freely. Rear window rubbers for club-cab windows are poor and windshield seal leaks There has been some patchwork done on the dash/instrument panel. Seats are ripped and door panels are weathered.
In person viewing can be arranged. Please send a message to arrange an appointment. VIN Breakdown: W = 4 wheel drive pickup 1 = 100 (1/2 ton) 7 = club cab sweptline J = 6,000 - 8,500 lbs (1979) F = 360ci 9 = 1979 C = Jefferson Plant
Buyer will be responsible for shipping but I can assist with coordinating or put the buyer in contact with a local shipper for a quote.